Posts: 57
Joined: Oct 2017
Reputation:
0
2018-05-09, 00:39
(This post was last modified: 2018-05-09, 00:40 by wedok.)
I'm using v3.4.5.2 with coreelec on a s905x box.
When i select a "dead" channel it hangs for about 20 seconds and then it jumps back to the home screen.
In theese 20 seconds i can do nothing. i can't switch to a working channel, etc.
No idea but, isn't it possible to detect a dead channel or channel with extreme low signal quality and then disconnect immediately and show a "no signal" message?
Posts: 632
Joined: Mar 2013
Reputation:
43
2018-05-09, 00:43
(This post was last modified: 2018-05-09, 00:44 by manül.)
> No idea but, isn't it possible to detect a dead channel or channel with extreme low signal quality and then disconnect immediately and show a "no signal" message?
Since the PVR is a client you are asking in the wrong forum. But I assume the answer is No.
Posts: 57
Joined: Oct 2017
Reputation:
0
yeah, the recording service monitors the dvb stream and when it detects no or bad frames it replaces them with good ones which have a "no signal" message picture in it.
*dream*
Posts: 632
Joined: Mar 2013
Reputation:
43
By the way one thing I thought about is adding a PVR specific timeout setting. This is possible in Leia. Right now the only way to change the timeout is modifying the global curl timeout. With this you can at least shorten the time.
Posts: 57
Joined: Oct 2017
Reputation:
0
2018-06-16, 18:37
(This post was last modified: 2018-06-16, 18:45 by wedok.)
hi,
i tried it with coreelec and pvr.dvbviewer-3.4.9.2.zip and set the value to "1 sec" but it still needs 20 seconds.
