2019-03-13, 16:30
When I had a PC running OpenElec, when I clicked the POWER button on the remote, it shut off the PC which also shut off the TV. The PC had a Flirc Streacom installed, very handy.
I switched to a Beelink GT1 Ultimate, and with my Sony Bravia (10yrs old) I pressed the POWER button, the box turned on and about 5sec later the TV turned on. Press the POWER button again, and absolutely nothing on either the Beelink or TV or KODI. Using the universal or original remote. I assume because after the Beelink turns on and boots to CoreElec on the SD card, the POWER button no longer works the same.
I switch to a TCL 6-Series 55" yesterday and now, I turn on the Beelink... and it goes on, that's all. When in Kodi and I go to shutdown, it turns off the Beelink, and the TV stays on asking if the source is still powered on/connected.
Sounds like a few issues... hardware and software. Hoping someone has some insight about
1 - Press POWER and it powers off the system instead of having to navigate to the power option on screen and click power off.
2 - When system shuts down, the TV shuts down. TCL TV so far is very nice.... but the manual kinda blows.
3 - Press POWER on and everything turns on like it did when the old SONY was attached. Didn't even need to program that, the TV just did it, assuming gotta be a way on a newer one.
Wasn't sure which forum area to post this in, figured other OS made sense since using CoreElec and Roku. Thanks
I switched to a Beelink GT1 Ultimate, and with my Sony Bravia (10yrs old) I pressed the POWER button, the box turned on and about 5sec later the TV turned on. Press the POWER button again, and absolutely nothing on either the Beelink or TV or KODI. Using the universal or original remote. I assume because after the Beelink turns on and boots to CoreElec on the SD card, the POWER button no longer works the same.
I switch to a TCL 6-Series 55" yesterday and now, I turn on the Beelink... and it goes on, that's all. When in Kodi and I go to shutdown, it turns off the Beelink, and the TV stays on asking if the source is still powered on/connected.
Sounds like a few issues... hardware and software. Hoping someone has some insight about
1 - Press POWER and it powers off the system instead of having to navigate to the power option on screen and click power off.
2 - When system shuts down, the TV shuts down. TCL TV so far is very nice.... but the manual kinda blows.
3 - Press POWER on and everything turns on like it did when the old SONY was attached. Didn't even need to program that, the TV just did it, assuming gotta be a way on a newer one.
Wasn't sure which forum area to post this in, figured other OS made sense since using CoreElec and Roku. Thanks